Hot Rods Countershaft Seal Kit - Yamaha Raptor 700 (2006-2014)

Fix That Leaking Countershaft Seal

Hot Rods countershaft seal kit for Yamaha Raptor 700. Everything you need to fix a leaking output shaft seal in one complete kit—no hunting for individual parts.

Why This Kit

✓ Complete solution in one box
✓ Fixes leaking countershaft seal
✓ Includes seal, bushing, o-rings, washer
✓ Hot Rods quality components
✓ Cheaper than OEM

What's In The Box

- Countershaft seal
- Countershaft bushing
- O-rings
- Sprocket nut washer (where applicable)

⚠️ Does NOT include water pump or transmission bearings

Fits These Raptors

✅ 2006-2014 Yamaha Raptor 700 (all models)

All YFM700R, YFM700RSE, YFM700 Raptor models 2006-2014

Quick Specs

Part #: OSK0047
SKU: 421-5047
Weight: 0.20 lbs
Application: Countershaft/output shaft seal repair

Signs You Need This

🚨 Oil leaking from sprocket area
🚨 Oil on chain or rear tire
🚨 Drips under bike after riding
🚨 Low oil level with no obvious leak elsewhere

Why The Seal Fails

Countershaft seals wear out from:
- Normal mileage/hours
- Dirt and debris getting behind seal
- Worn bushing causing shaft wobble
- Chain tension pulling on shaft

Installation Notes

⚙️ Difficulty: Intermediate
🔧 Tools needed: Seal driver, impact wrench, torque wrench
👨🔧 Time: 1-2 hours

Access is easy—no case splitting required!

Install Process

1. Remove rear wheel and chain
2. Remove sprocket nut
3. Pull sprocket off shaft
4. Remove old seal and bushing
5. Install new bushing and seal
6. Reinstall sprocket with new washer
7. Torque nut to spec
8. Done!

Pro Tips

💡 Replace any time you remove the sprocket
💡 Check chain alignment after install
💡 Use seal driver—don't hammer it in crooked
💡 Apply grease to seal lip before installing
💡 Torque sprocket nut properly (prevents loosening)

Common Mistake to Avoid

❌ Don't reuse the old bushing—it's probably worn and will cause the new seal to leak again. This kit includes a new bushing for a reason.

Pairs With

- Rear sprocket (if worn)
- Drive chain (if stretched)
- Engine oil (top off after fixing leak)
- Sprocket lock washer
- Thread locker

Warranty

🛡️ Hot Rods manufacturer warranty
🔄 No returns on installed seals

Questions?

📞 541-668-7503
📧 Support@dunegoonshop.info

Ships same day before 3pm EST ⚡
6 in stock and ready to ship!